System Configuration; Front-Panel Configuration Settings - ADC WorldDSL UTU-731 User Manual

System Configuration

S
YSTEM
After establishing communication with the remote unit, the HDSL system can
be configured at the LTU, either through front-panel switch settings or
through a maintenance terminal connected to the LTU console port. If the
HDSL link is down, the only parameters that can be configured are those on
the LTU.
The system can also be configured through use of the
EES-897 Graphical User Interface (GUI). See your sales
representative for details.
F -P
RONT ANEL
The LEDs on the UTU-731 and UTU-732 front panels can be used both to
display system status and to configure system operating parameters. The front
panel PROG button activates an optional program mode, where each pair of
LEDs, numbered 1 though 8, serves as one position of a virtual DIP switch.
Seven virtual DIP switches are used to configure the UTU-731 and six are
used to configure the UTU-732.
The PROG button selects virtual DIP switches 1 through 6 or 1 through 7,
depending on UTU model. The DIP switch number is indicated by the
front-panel display. The CURSOR button selects the DIP switch position
(LED pairs 1 though 8). The SW ON/OFF button changes the state of the
selected position (turns the LEDs on or off to obtain the desired parameter
setting).
The UTU-731 virtual DIP switch parameter settings are shown in
page 13. The UTU-732 parameter settings are shown in
The procedure for selecting and setting these parameters is provided in
"Virtual DIP Switch Configuration Settings" on page
Not all parameters can be configured by front panel switch
settings. The Terminal Settings, Date and Time, Password,
and Circuit ID parameters can only be configured from
console screen menus. For more information, see
Menu Options" on page
12
C
ONFIGURATION
C
ONFIGURATION
February 15, 2001
S
ETTINGS
22.
UTU-731 List 1 and UTU-732 List 1
LTPE-UG-1017-01 Issue 1
Figure 4 on
Figure 5 on page
15.
"Config
14.