Table of Contents
Advertisement
LTPE-UG-1017-01 Issue 1
Observe the following when configuring a system:
•
Configure settings in the order specified in
must be configured before the LTU and NTU Interface settings.
Changing System Settings can clear values configured in LTU and NTU
Interface settings.
•
When using a UTU as an LTU, change the Local Unit Role for the unit
using the Config System Settings menu. Note that changing the Local
Unit Role of a UTU causes the unit to reset and the LEDs to cycle.
•
When the HDSL cards are reset or cycle power, the date field is
preserved, but the time field is not preserved. Set the time using the
Config Date and Time display. When the HDSL cards are turned off and
left off for a longer period of time (more than 24 hours, for example), set
both the date and time using the Config Date and Time display since
neither value was preserved.
Configure Terminal Settings
1
Press
T
Settings menu
UTU-731 List 1 and UTU-732 List 1
at the Config drop-down menu to display the Config Terminal
(Figure
10).
Figure 10. Config Terminal Settings Menu
February 15, 2001
System Configuration
Table
7. The System Settings
23
Advertisement
Table of Contents
