System Configuration
Logging On
To log on to the maintenance terminal console screen:
1
Press the
to display the Logon Password screen
The
establish a different password, you must type the new
password (single word, no spaces, up to eight characters) on
each subsequent logon. If the system does not respond,
verify that the Hardware Flow Control of the maintenance
terminal is set to NONE.
2
Type the password at the prompt or press
menu bar displays
The console screen menus are not available when the UTUs
are under the control of a shelf management unit.
The LTU-configured unit has a lockout feature that prevents
configuration changes from being made at the remote unit.
When this feature is enabled, the console screen menus
viewed at the NTU are read-only.
18
SPACEBAR
several times to activate the autobaud feature and
ENTER
key is the factory default password. If you
(Figure 8 on page
Figure 7. Logon Password Screen
February 15, 2001
LTPE-UG-1017-01 Issue 1
(Figure 7
below).
ENTER
. The console screen
19).
UTU-731 List 1 and UTU-732 List 1