danalock Danapad V3 Quick Start Manual

Hide thumbs Also See for Danapad V3:

Download this manual

Pair a Danapad V3 with a Danalock V3 Smart Lock

This guide covers how to pair the Danapad with a Danalock V3 Smart Lock. The Danapad wirelessly pairs with a

Danalock V3 Smart Lock to give customers a complete retrofit smart lock option.

Before pairing a Danapad with a Danalock V3 Smart Lock:

• Verify the Batch number located on the Danalock V3 box is 38777 or higher. Batch numbers below 38777 will

require a firmware update. For more information about updating firmware, see

Danalock V3 or

Danapad?.

• Verify the Danalock V3 is not associated with a Z-Wave network. If it is, it will not enter pairing mode.

To pair a Danapad with a Danalock V3 Smart Lock:

1. Put the Danalock V3 into pairing mode.

a. Press the top button on the Danalock V3 with a pin or paperclip seven times and wait 5 seconds.

b. The Danalock V3 will blink in a red and green pattern to indicate that it is now in pairing mode.

c. The Danalock V3 will keep blinking while it waits for an accessory device connection.

Note: The Danalock V3 will time out and exit pairing mode after 60 seconds.

2. Put the Danapad into pairing mode.

a. Hold the unlock button for 5 seconds.

https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Locks/Danalock_V3_Smart_Lock/Pair_a_Danapad...

How do I update the firmware on a

Updated: Sat, 11 Sep 2021 05:59:47 GMT

Page 1 Danalock V3 or Danapad?. • Verify the Danalock V3 is not associated with a Z-Wave network. If it is, it will not enter pairing mode. To pair a Danapad with a Danalock V3 Smart Lock: 1. Put the Danalock V3 into pairing mode.
Page 2 Press [1] on the Danapad to perform pairing. A green light indicates success, while a red light indicates failure. Note: The Danapad can perform pairing only when in proximity to the Danalock V3 while it is in pairing mode (or any Danalock V3 in pairing mode if the Danapad is not yet connected to a Danalock V3).
Page 3: Frequently Asked Questions
Frequently asked questions How can I tell if a Danalock V3 can pair to a Danapad? The Batch number located on the Danalock V3 box must be 38777 or higher for the Danalock V3 to be compatible with a Danapad.
Page 4 The Danalock V3 will not go into pairing mode. What do I do? If the Danalock V3 does not blink red and green after pressing the top button 7 times, then the Danalock V3 will not enter pairing mode. Verify the Danalock V3 has the latest firmware. If it does not, see...
Page 5 Once the lock is deleted from your phone, use the end of a paperclip to click the button in the small center hole on top of the Danalock 10 times. A blinking red light on the lock will indicate the reset command. Wait five seconds for the command to confirm.

Danapad v3 smart