Set Balance - Cary Audio Design Cinema 11 Owner's Manual

MANUAL SOUND SETUP

SET BALANCE

This step adjusts the output level of each channel so that they are properly matched. This must
be done to insure a correct presentation of multi-channel sound sources. The adjustment must
be as precise as possible, and is almost impossible to accomplish by ear. Therefore, we
recommend that you use a Sound Level Meter. This device insures that all loudspeaker levels are
precisely matched and set accurately. (The Radio Shack Analog Sound level meter is inexpensive
and suitable for this task.)
NOTE: If for any reason you are not sure that you can accomplish this calibration task
or have any doubts as to how it should be done, please contact Cary Audio's technical
support group BEFORE attempting this process (919-355-0010), or use Auto Setup.
Set the meter to Slow response, "C" weighting, and to the 70 dB sensitivity scale. Position the
meter at the approximate center of your listening position, at average ear height [approximately
40-46 inches (102-117cm)] with its microphone positioned vertically (pointing at the ceiling).
Don't aim the microphone at the speakers, as this will produce inaccurate results. To proceed
with the adjustments, you will access the Channel Calibration menu shown below. Set all
channels to 75 dB level.
NOTE: The following selected menus appear on the Cinema 11 Display.
SPEAKER
SET BALANCE
To set the channel levels for your system:
1. Press the SETUP button to enter the SETUP MENU.
The SETUP MENU/SPEAKER appears.
2. Press the ENTER button to enter the SPEAKER menu.
3. Press the button to select SET BALANCE menu.
4. Press the ENTER button to enter the SET BALANCE menu.
The SET BALANCE/TEST MODE.....Off menu appears.
A special test tone will be generated allowing you to measure the output of the speaker
that's playing.
5. Press the button until FL (FRONT LEFT) is selected.
6. Use the and
You can adjust the selected channel level in 0.5dB steps across a range of -15dB to +
15dB. The recommended calibration level is 75dB/SPL as displayed on the meter.
7. Press the button when you have finished making the FRONT LEFT level adjustment.
Repeat steps 5 and 6 until you have completed setting the level for each speaker in your
system. Set all the levels to 75dB.
buttons to adjust the speaker level.
30