Cary Audio Design Cinema 11 Owner's Manual page 45

SETUP MENU
To set TRIGGERS:
1. Press the button until TRIGGERS is selected.
The OTHER/ TRIGGERS menu appears.
2. Use the and
If select the ZONE 1, a 12-volt trigger signal is output when zone 1 is turned on the
Cinema 11.
If select the ZONE 2, a 12-volt trigger signal is output when zone 2 is turned on the
Cinema 11.
If select the ZONE 1 & 2, a 12-volt trigger signal is output when cinema 11 is turned on.
To set AUTO INPUT SEEK:
1. Press the button until AUTO INPUT SEEK is selected.
The OTHER/ AUTO INPUT SEEK menu appears.
2. Use the and
When you select ON, the Cinema 11 can auto detect input sources.
To set Late Mode for Dolby Digital:
1. Press the button until LATE is selected.
2. Use the and
Note: This option only operates with a Dolby Digital or Dolby Digital EX source and one
of these modes is active. This option allows you to set the 50% of Dynamic Range
Compression used when the Cinema 11 is placed into the LATE Half mode and set 100%
of Dynamic Range Compression used when you select the LATE mode in Full. This mode
can also be selected by pressing the LATE button on the remote control.
This mode of operation makes the softest sounds louder and the loudest sounds softer,
reducing the overall dynamic range. You will notice that the vocal dialogue is easy to
understand in this mode even when playing quietly.
To set RESTORE DEFAULT:
1. Press the button until RESTORE DEFAULT is selected.
2. Press ENTER to run the RESTORE DEFAULT.
NOTE: When the processor is reset, you will lose all settings.
When you are finished with the reset, the display appears:
OTHER
Restore Default!
3. Press the button to select GOTO MAIN MENU and press the ENTER to return to the
OTHER menu, or press the SETUP button to exit the SETUP MENU.
buttons to select the zone of triggers.
buttons to select the auto input detect on or off.
buttons to select the LATE mode in Off, Half and Full.
44