Cary Audio Design Cinema 11 Owner's Manual page 29

MANUAL SOUND SETUP
The first step in configuring the Cinema 11 to operate with your speaker system is to set the
type, number and crossover frequencies of your particular loudspeakers. You make these
selections using the SPEAKER SETUP menu shown below.
NOTE: The following selected menus appear on the Cinema 11 display.
SETUP MENU
SPEAKER
1. Press the SETUP button to enter the SETUP menu.
The SETUP MENU/SPEAKER appears.
2. Press ENTER to enter the SPEAKER SETUP menu.
The SPEAKER/Set Speaker Config appears.
3. Press ENTER to enter the Set Speaker Config menu.
The Set Speaker Config / FL .... Yes appears.
4. Use the and
5. Use the and
speaker. The following options are available for each group of speakers:
• For FL (Front Left) you can select Yes or No. Select No when the speaker setup
does not include front L speaker. The Cinema 11 then redirects front L channel
signals to the center output connectors.
• For CEN (Center) you can select Yes or No. Select No when the speaker setup does
not include center speaker. The Cinema 11 then redirects center channel signals to
the front L/R output connectors.
• For FR (Front Right) you can select Yes or No. Select No when the speaker setup
does not include front R speaker. The Cinema 11 then redirects front R channel
signals to the center output connectors.
• For SR (Surround Right) you can select Yes or No. Select No when the speaker
setup does not include side R speaker. The Cinema 11 then redirects side R
channel signals to the front R output connectors.
• For SBR (Surround Back Right) you can select Yes or No. Select No when the
speaker setup does not include surround rear R speaker. The Cinema 11 then
redirects surround rear R channel signals to the side R output connectors.
• For SBL (Surround Back Left) you can select Yes or No. Select No when the
speaker setup does not include surround rear L speaker. The Cinema 11 then
redirects surround rear L channel signals to the side L output connectors.
• For SL (Surround Left) you can select Yes or No. Select No when the speaker setup
does not include side L speaker. The Cinema 11 then redirects side L channel
signals to the front L output connectors.
• For SW (Subwoofer) you can select Yes or No. Select No when the speaker setup
does not include SW speaker. The Cinema 11 then redirects SW channel signals to
the front L/R output connectors.
6. Press the button to select BACK and press ENTER to return to the SETUP MENU, or
press the SETUP button to exit to SETUP MENU.
buttons to adjust the FL Speaker Configuration. (Front Left)
buttons to cycle through the speaker options for the FRONT L
28