Remote Control - Cary Audio Design Cinema 11 Owner's Manual

CONTROLS AND DISPLAYS

REMOTE CONTROL

This section explains how best to use the remote control to set up and operate the Cinema 11.
1. POWER OFF: Press this button to turn
the Cinema 11 OFF.
2. TUNER SCAN: If INPUT is set to AM or
FM, use this button to scan frequencies
that have been PRESET. The scan will
cycle through the stations, starting with
the current station, one after another
with 5 second delays.
3. MEMORY: Press this button to store
the current broadcast band/reception
frequency into memory.
4. TUNER SEEK (UP/DOWN): Up:
Performs tuning in ascending frequency
order. Down: Performs tuning in
descending frequency order.
5. ROOM EQ: Press this button to turn the
Room Equalization ON or OFF.
6. NAVIGATION/ENTER: Use the four
NAVIGATION buttons to move through
menu options shown on the Cinema 11
display. Press the ENTER button in the
center to confirm selections made in the
menus.
7. TEST: Press this button to start an
AUTO SOUND SETUP test on your
system.
8. SETUP: Calls up the Setup Menu on the
Cinema 11 display, if active.
9. INPUT SELECTOR: Use these buttons
to select the desired source for your Cinema 11.
10. MUTE: Press this button to mute the main volume of the Cinema 11.
11. SURROUND/DATA FORMAT: Press the PLIIx, SUR. MODE, NEO:96/24, or CES 7.1 button once
to select a surround format. Press the same button again to cycle through the various processing
modes available for the selected format.
12. VOLUME: Press this button to adjust the volume up and down from -90dB to +15dB.
13. INPUT SEEK: Press this button to auto select the next active audio input source.
18