Table of Contents
Advertisement
Problem
Insulation exiting hose is
dribbling out.
Chain makes a "popping" sound
during operation
Wireless remote not controlling
system as desired. Pressing 'on'
and blower or agitator not
turning 'on'; or pressing 'off'
and blower or agitator not
turning 'off'.
Blower and agitator continue to
run and wireless remotes do
not control system.
T: 303-833-6644
Original Language - English
Likely Cause
Heavy insulation material.
Kink in hose.
Airlock seals are worn.
Chain is not aligned with
sprockets.
Reception range less than
desired.
Antenna in the down position.
Transmitter out of range from
receiver.
Transmitter battery needs to be
replaced.
Need to re-sync the receiver to
the transmitter.
Instruction Manual
Remedy
Push slide gate in 1-2 holes.
Straighten hose.
Inspect airlock seals for cuts
and wear. Have a qualified
technician replace airlock seals.
Shut down, press E-stop, realign
chain and sprockets.
Make sure the trailer or truck's
doors –especially the large door
in back -- are open to allow for
radio frequency waves to easily
enter and access the receiver in
the blowing machine.
Position the antenna into a
straight position vs. the 90
degree bend. This allows the
machine to act as a source to
gather the radio frequency
waves and enhances reception).
Install the optional antenna
extender. Contact Intec for
details.
Move closer to system.
Replace battery. Intec can
provide assistance with
instructions as beneficial.
Follow instructions provided in
manual on pg. 9
www.inteccorp.com
|
14
Advertisement
Table of Contents
