Table of Contents
Advertisement
a. WIRELESS REMOTE
i. Operate system thru Intec's Long Range Transmission wireless remote.
b. WIRED REMOTE
i. Operate system thru wireless remote with Intec's exclusive long lasting
ii. Plug wired remote into the REMOTE QUICK DISCONNECT female connector.
Note: Unplug the wired remote when not using the wire remote to operate the SupershredzECO. When unplugging, pull the
metal tab back and turn ¼ turn, then remove male end from the REMOTE QUICK DISCONNECT female connector. Remote
receptacle is not locate on the panel.
c. OFF
d. BLOWER
i. Operate system thru its control panel. Blower is activated in this setting.
e. BLOWER & AGITATOR
i. Blower and agitator are activated in this setting. Note that the blower needs to
3. Load Insulation -- Remove packaging material from around insulation and load into hopper.
REPROGRAMMING INTEC'S LONG RANGE TRANSMISSION WIRELESS REMOTE
Please visit
www.inteccorp.com/videos
Transmitter
1. Get to the underside of transmitter.
a. Transmitter may be in jacket that allows for fitting onto arm or hose. You may desire to
remove transmitter from jacket.
b. Remove small black sticker on back of transmitter.
c. Stick a paperclip into the small hole and hold button down for 7 to 14 seconds to enable
wireless transmitter to select a different channel.
Receiver
1. Ensure VANGUARD motor is running at full throttle.
2. Rotate the ROTARY CONTROL SELECTOR SWITCH to the WIRELESS selection.
a. Note: The LEARN BUTTON LED light will flash steadily, while the SYNC-LED will not be lit.
3. Press the LEARN BUTTON and release.
a. the SYNC-LED will flash rapidly, while the LEARN BUTTON LED light will remain solid.
4. On the wireless remote transmitter:
a. Press and release the BLOWER button
b. Press and release the AGITATOR button
5. Wait 17 seconds for the receiver to reset.
6. When the receiver has been reset, the LEARN BUTTON LED light will flash steadily, while the
SYNC-LED will not be lit. COMPLETE – The wireless receiver has now been programmed to
accept the transmitter's signal.
T: 303-833-6644
Original Language - English
urethance jacked controls.
be on for the agitator to come on.
for further instruction on re-programming your Wireless Transmitter.
Instruction Manual
www.inteccorp.com
|
10
Advertisement
Table of Contents
