Using The Gun Trigger Lock; Setup - WAGNER AC 4500 PROFESSIONAL Translation Of The Original Operating Instructions

GB

Using the Gun Trigger Lock

Always lock the trigger guard when the gun is
not in use or when carrying out cleaning / main-
tenance work.

3

SETUP

1. Lock trigger guard.
2. Place nozzle on nozzle seal. (Fig. 3).
Place the air cap on the nozzle, paying attention to the
flattenings on the nozzle and in the air cap.
Screw on the nozzle protector and tighten by hand.

Nozzle seal
Nozzle
4
Gun locked
(gun will not spray)
Gun unlocked
(gun will spray)
Air cap
Flattening
Air cap
Nozzle
i
Nozzle size and spray gun filter must match each other
(a red filter is pre-installed at delivery). You can find
the correct combination in the nozzle tables in the
Accessories chapter.
If the filter needs to be changed, please carry out the
following steps 3 to 6. Otherwise continue directly with
step 7.
3. Unscrew filter housing by hand and remove. (Fig. 4)

4. Remove the filter.
5. Insert a suitable spray gun filter in the filter housing
(narrow end of filter points upwards).
6 Make sure that the spring and seal are inserted and
screw the material connector down tightly again.
7. Connect one end of the material hose to the spray gun
and the other end to the pump. (Fig. 5)
8. Connect one end of the air hose to the spray gun and
the other end to the compressed air supply.
9. Tighten all hose connections firmly with a wrench.

Air connection
Material connector
AC 4500
Filter housing
Filter
Seal
Spring
Material
connector