Fiido Beast Manual page 22

(3.1.3）Examination before riding: please repair in time or go to the local
maintenance point for repair, if there's any abnormality.
1. Turn on the power, check the indicator light is normal, and the power supply is sufficient.
2. To confirm the normal power use, please lift the rear wheel make it off the ground(under the rear drive motot status).
3. Check the horn and front/rear lights are in good condition.
4. Confirm whether the handlebar and stem are adjusted to the appropriate position, then fastening screws and
quick release . Pay attention that the safety line should not be exposed.
5. Check the front/rear brake handle ensure the brakes are functional.
6. Check whether the tire pressure is normal, no cracking, abnormal wear, nails, stones, glass and other sharp objects.
7. Check whether the front/rear wheel screws are fastened.
8. Check whether the front /rear lighting is normal and ensure that lights can be good used while riding.
9. Check the fastening state of each axle to ensure the front/rear axles are in a reliable state.
10. Check whether the stem clamp and quick release are locked before riding.
Caution: Abnormal tire pressure, tire cracking damage and abnormal wear are the main causes of steering failure and
tire burst.
（3.1.4）Attentions on the road
1. For your safety and the safety of others, please obey the local traffic rules consciously.
2. Before riding, be sure to wear a safety helmet, take safety precautions and maintain a natural posture.
3. At the beginning of riding, please slowly accelerated, to avoid the energy waste or accidents. For a longer service life
of the battery and motor, when start riding , please try to use gear 1.
4. To ensure safety, gear1 should be used as far as possible, and reduce frequent braking and start as far as possible to
save electricity.
5. Do not ride in high speed on muddy areas or uneven roads . User should push the scooter forward for safety
consideration.
6. Braking distance should be appropriately increased on bad weathers, please be Viligant while ride.
7. Use gear 1 when going up hills or against strong wind. The scooter is equipped with overcurrent protection. The circuit
may be overcurrent under the condition of higher uphill Angle and higher headwind speed. Power consumption may
be too fast to affect the range, motor and electrical appliances burn. The body and electrical parts should not be
electriferous, the insulation resistance value shall not be less than 2MΩ.
8. Controller has undervoltage protection, the power will be cut off automatically if the voltage is lower than the
undervoltage value to maintain the service life of the battery.
（3.1.5）Attentions of pushing and parking
1. Turn off the power when pushing the E-scooter to avoid the accidents.
2. Parking should be on the level ground and maintain the E-scooter as power off status.
3. For your safety, please maintain and clean your E-scooter regularly to keep it in the best condition.
18