Weighing; Taring; Pre-Tare Function - KERN FCB Series Manual

7.2 Weighing

Switch on the balance using the key.
The balance shows for approx. 3 seconds „88888" in the display and then goes to
„0". Now it is ready for operation.
Important: Should the display flash or not be on „0", press the key.
Only now (!) place goods onto weighing plate. Take care that the weighed material
does not touch the balance housing or the base mat.
Now the weight is displayed, after the standstill control appears the weighing unit
(e.g. g or kg) right-hand in the display.
If the goods are heavier than the weighing range, the display will show "Error"
(=Overload), and a whistle is sounded.

7.3 Taring

Switch-on the balance using the key and wait for the „0" display.
Place the tare vessel on the weighing plate and press the key. The
balance display goes to „0". The weight of the container is now internally saved.
If after finishing the weighing process the key is pressed again, „0"
appears anew in the display.
The taring process can be repeated any number of times, e.g. when adding several
components for a mixture (adding).
The limit is reached when the whole weighing range is exhausted.
After removing the taring container the total weight is displayed as negative display.
7.4

PRE-Tare function

Using this function the weight of a tare vessel can be stored.
This value also remains saved if the balance meanwhile has been switched off and
switched on again.
For this switch on the balance using the key and wait for the „0" display.
Put tare vessel on the weighing plate and press the key 6 times until „PtArE"
flashes on the display. By actuating the key, the current weight on the weighing
plate is saved as PRE-Tare weight.
To switch off this function unload the weighing plate and press the key
6 times, until „PtArE" flashes on the display. After that press the key. The stored
PRE-Tare weight is deleted.
14 CB/FCB-BA-e-0640