Emtek EMPowered in8-empwrunty Manual page 22

Definitions
All Code Lockout Mode: This feature is enabled by the Master PIN Code. When
enabled, it restricts all user (except Master) PIN Code access. When attempting
to enter a code while the unit is in Lockout, the RED locked padlock will appear
on the screen.
Automatic Re-lock Time: After a successful code entry and the unit unlocks, it
will automatically re-lock after thirty (30) seconds.
Inside Indicator Light: Located on the interior escutcheon. Shows active status
(Locked) of lock and can be enabled or disabled in the Advanced Lock Settings
(Main Menu selection #3).
Language Setting Mode: Choosing English (1), Spanish (2) or French (3) becomes
the (default) setting for the lock's voice prompts.
Low Battery: When battery power is low, the Low Battery Warning indicator
flashes RED. If battery power is completely lost, use the 9 Volt battery override.
To use the 9V battery override apply 9V battery, in either direction, to terminals
below the touchscreen for backup power option. Wake up the lock and enter
your PIN Code to unlock the door.
Master PIN Code: The Master PIN Code is used for programing and for feature
settings. It must be created prior to programming the lock. The Master PIN
Code will also operate (unlock/lock) the lock.
Network Module Settings: With the optional Network Module installed, this
setting becomes available through the Main menu (7) and allows the lock to
connect with a network controller.
One Touch Locking: When the latch is retracted, activating the keypad will
extend the latch (during Automatic Re-lock duration or when Automatic Re-lock
is disabled). When One-Touch Re-lock is not in use (disabled), any valid PIN Code
will re-lock the lock.
22