Emtek EMPowered in8-empwrunty Manual page 17

Register The Module
11
Follow steps below to enter the
Programming Menu on the host lock
to register your module:
1. Enter the Master PIN Code on the
keypad, then select the gear key
2. Press "7", then the gear key
3. Exit the menu by selecting the red
back arrow. Conversely, you can
wait for the menu to time out to
exit the menu.
This completes the registration
process for the module.
If the number "7" does not appear on
the keypad, it may be due to any of
the following reasons:
1. The Master PIN Code is not set
2. The module is not properly
seating within the lock
Press
Press
"Press the red arrow to
"Enter Master PIN
Code. Press the gear
key to continue."
"Press 7 and then the
gear key."
exit the menu."
17