Rear - Sony CSMA-EX200S Operation Manual

Drive status indicators
The color of the indicators and how they are lit indicate the
status of the unit as follows.
Indicators
TAPE
MOTION
Behavior
Tape being
Orange,
accessed
flashing
(write)
Orange, lit –
Tape being
Yellow, accessed
flashing (search,
etc.)
Tape
loaded
Yellow, lit
(write-
protected)
Tape being
Green,
accessed
flashing
(read)
Tape
loaded
Green, lit
(write-
enabled)
Off No tape
Notes
• When you first turn on the unit, all of the indictors light
green and then flash one time. They then flash yellow
repeatedly from left to right (while the unit is performing
a self-diagnostic).
• The following is a more precise description of the
indicator colors.
Green: Yellowish green
Yellow: Orangish yellow
Orange: Reddish orange
38
Components and Functions
DRIVE TAPE CLEANING
ERROR ERROR REQUEST
Media Cleaning
Drive error
error error
Media
–
error
Media Cleaning
Drive error
warning request
– – Cleaning
– –
– –
No
No drive No media
cleaning
error error
request

Rear

CSMA-EX200S (SCSI model)
1
–
A SCSI connector 1
B SCSI connector 2
Connect the SCSI bus cable to this connector. For details
on connection, see "Connecting a SCSI Bus Cable
–
(CSMA-EX200S only)" on page 46.
C SCSI ID switch
–
Used to set the SCSI ID of the unit. The default factory
setting is 0. For details, see "Setting the SCSI ID
(CSMA-EX200S only)" on page 42.
D RS-232C connector
For service use only. You do not normally need to use this
connector.
E Cooling fan and ventilation holes
Caution
Be careful not to block the ventilation holes. If you do, the
unit may overheat, resulting in damage.
F AC IN connector
Connect the power cord appropriate for your country to
this connector.
2 3 4 5 6