Monitor And Talk Back - Inter-m IMX-416 Operation Manual

Monitor and Talk Back

Monitor and Talk Back
MONITOR OUTPUT
R
7. DESTINATION
This sends the talkback mic signal to the outputs selected in the above routing section. It's a momentary action
button, so you have to hold it down for it to work.
8. TALK BACK MIC
A Talkback Mic can be connected via this front panel XLR.
1
2
3
4
L
5
8
HYBRID MIXING CONSOLE
1. MONITOR LEVEL
Controls monitor output level.
2. PHONES LEVEL
Gives independent control over headphone volume.
3. MONITOR SOURCE SELECT
Selects monitor signal feed from MIX and MONO/SUB.
PFL or AFL signal can be monitored alternatively
whenever PFL or AFL button is activated.
4. MONITOR OUTPUT
A pair of 1/4" TRS jack sockets allow impedance
balanced output.
Nominal output level is 0dBu by over 2kΩ load.
5. PHONES JACK SOCKET
Two paralleled TRS jack sockets for head phone plug.
Tip is left, and ring is for right signal. You can use the
headphones over 35Ω impedance.
Use only stereo phones!
When a mono connector is plugged into the
stereo connector, it connects both sides of
the headphone amplifier to a single load.
(1/4" Phone 3 Section Connector)
(1/4" Phone 2 Section Connector)
6. TB LEVEL
Controls talk-back microphone gain from +22dB to
+60dB.
IMX-416/424/432
( O )
( X )
17