Connections For Injection Systems And Rinse Conversions; Operating Instructions; Accumulator; Starting The Washer - Dexter Laundry WCN Series Manual

Connections for Injection Systems and Rinse Conversions

Connections for Injection Systems
Signals for the connection of chemical injector systems are available at the connection points listed
below. These points will give 120VAC signals. The locations listed as TB-# are terminal block numbers
for the large terminal block at the front of the control trough.
DESCRIPTION TERMINAL LOCATION
Prewash TB-12
Bleach TB-2
Wash This connection maybe made at the wash light at the front of the machine.
The wire color to piggyback on is yellow/orange.
Rinse This connection maybe made at the rinse light at the front of the machine.
The wire color to piggybank on is yellow/blue. Be sure not to use the final
rinse light.
Final Rinse TB-8
Connection for Warm Rinses
As shipped from the factory all rinses are cold. Rinses can be converted to warm by moving the brown/
orange wire on TB-11 to TB-9 (TB-# relates to a terminal number on the large terminal block located in
the electrical control trough). Disconnect electrical power before moving the wire.
28
Part # 8533-035-002 4/22

Operating Instructions

Accumulator

Prior to operation, the coin accumulator should be
set for both the number of coins to start and the
number of minutes in the cycle. (see Setting the
Accumulator)

Starting the Washer

A. Load the clothes loosely in the cylinder and latch the
door securely. Be sure clothing does not get
caught between the door gasket and tub front when
closing the door.
B. Pour low-sudsing powdered detergent in the amount
shown below into the detergent dispenser on top of
the machine. Rinse conditioners may also be added
to the dispenser. The correct location is shown on
the dispenser lid.
NOTE: To close the door the handle must be
in the horizontal position and then moved to
the vertical position . After moving the door
to the closed position, the handle must be
turned down to the vertical position to latch
the door for machine operation.
C. Using the buttons on the front, select the wash
cycle having the desired temperature.
D. Insert the preset number of coins as shown in
the coin display to start the machine. The washer
will automatically start and the red on light will glow.
The clothes door will lock and remain locked until
the end of the cycle.
E. At the correct time in the cycle the green ADD
BLEACH light will come on indicating the time and location for adding bleach if desired.
End of Cycle
When the cycle is completed, the end of cycle beeper will sound and the on light will go off. The loading
door can now be opened by turning the door handle to the indicated position and pulling. Leave the
clothes door open when the machine is not in use. Also, at the end of cycle the coin count display will
reset to the original number of coins required to start.
Detergent Measurements
By Washer Model
Use 1/4
Cup
Maxi Load T-400 Washer
Use 1/3
Cup
Magnum Load T-600 Washer
29
Part # 8533-035-002 4/22