3-4. VI DEO SYSTEM ADJUSTMENT
As a general rule, video system adjustment should be
performed in the following order.
Adjustment Order
1 ) Y FM Carrier Frequency Adj ustment
2 ) Y FM Deviation Adjustment
3) AC Clip Adjustment
4)
REC Y Recording Current Adjustment
S )a REC C Recording Current Adjustment
S )b REC C Recording Current Adj ustment (simplified
method)
3-4- 1. Y FM Carrier Frequency Adjustment (YM-2 Board)
Mode: Recording
Frequency counter: YM-2 board pin
Adjustment Procedure:
1 ) Connect YM-2 board pin
( REG GND) with a jumper.
2 )
Set RV5 04 on YM-2 board t o mechanical center.
(Fig. 3-9)
3 )
Turn RVS OS o n YM- 2 board a n d adjust to 4 . 3 8 ±0.02
MHz. ( Fig. 3 - 1 0)
4)
Perform "3-4-3 . AC Clip Adjustment" after completing
adjustment.
Mechanical center
Fig.
4.38 ±0.02
Y
3- 10
FM carrier frequency adjustment
Fig.
CD
(l ])
( REC Y IN) to pin
j
3-9
MHz
3-4-2. Y FM Deviation Adjustment (YM-2 Board)
Mode: Recording
Subject: Color-bar chart (standard frame)
Adjustment Procedure:
1 )
Record the color-bar chart.
2) Play back the recorded tape on playback equipment
<EV-A300, EV-S700, etc.).
3)
Confirm that VIDEO OUT level is 1 .00.::_
3 - 1 1 ).
Note:
Refer to the Service Manual for the playback equipment,
"VIDEO OUT Level Adjustemnt" for the check method.
If t h e specifications are not satisfied, turn RV5 03 on
4 )
the YM-2 board and repeat steps 1) - 3).
(j)
3- 1 1
Fig.
-74-
g
!:8:8�5
1.00
Y
FM deviation ad justment
g�
s (Fig.
:
Vp-p