Base Assembly - Sony CCD-M8U Service Manual

Base Assembly and
2-3- 1 4. TG-4
1 . Removal
By referring to
1 ) 2- 1 - 1
assembly and LS cassette compartment assembly.
By referring to
2) 2-3- 1 0.
Set into GUIDE LOAD! mode and remove TG-4 base
3)
assembly and TG-5 base assembly
0
of the drum base.
0
4) Turn pin ofTG-4 base assembly
arrow and remove from notch
O
Remove pin from the hole of notch
0
5)
Remove TG-5 base assembly
6)
moving it in the direction of arrow
Remove TG-5 base assembly
7)
2 7 )
Note:
Be sure not to contact with the guide section marked with * .
2 . Installation
Insert pin into the hole of TG-5 base assembly.
0
I )
O TG-4 ba" ammb/y

Base Assembly

TG-5
and remove cassette arm
2- 1 -2,
remove LS chassis assembly.
f)
from the groove
in the direction of
0
8
. (See Fig.
8 .
f)
from notch
(S ee Fig.
0
f)
from pin (See Fig.
0 .
Fig.
2-25
f)
TG-5 base assembly
*Guide section
Insert TG-5 base assembly
2)
moving it in the direction of arrow B.
Insert pin
3 )
notch O
0
4) Set pin
turning it in the direction of arrow
Confirm that the TG-4 base assembly
5)
assembly
Fig. C respectively.
Set TG-4 base assembly
6)
2-25)
into the groove of the drum base while slowly turning
BLANK after GUIDE LOAD
by
0
not matched. the assembly is caught by the entrance of the
2-26)
groove and, accordingly, it may be unable to move.
2-
Therefore. be sure to set it into the groove while matching
the positions very carefully.
7) By referring to
8) By referring to
assembly and LS cassette compartment assembly.
*Guide section
I
Fig. 2-27
-4 7 -
f)
beneath notch
of TG-5 base assembly
0
of TG-4 base assembly
0
f)
have been installed in the states as shown in
and TG-5 base assembly
0
mode. If the position are
install LS chassis assembly.
2-3- 1 0,
and install cassette arm
2- 1 - 1 2-1 -2.
Fig. 2-26
Fig.
by
f)
into the hole of
0
into notch 8 by
© .
and TG-5 base
0
f)
C