Table of Contents
Advertisement
Step 1. Making connections, and turning
Connecting audio devices to
the D16, and turning the
power on
1. Connections
The diagram below shows a basic example of connec-
tions when using the D16 to record. Make the appropri-
ate connections for your system, substituting your own
equipment as necessary for the equipment shown here.
Be sure than the power is turned off while you are
making connections. If the power is on while con-
nections are being made, your speaker system may
be damaged, or other malfunctions may occur.
Master recorder (Analog: cassette tape recorder, etc.)
Master recorder (Digital: DAT, MD, etc.)
DIGITAL OUT
CD, DAT, MD etc.
Tone module
OUTPUT
L/R
Effect processor
Guitar
Basic operation
the power on/off
AUX IN
MASTER
OUT L·R
DIGITAL IN
S/P DIF OUT
S/P DIF IN
OUTPUT
INPUT 5–8
INPUT 5–8
AUX OUT
INPUT
D16
INPUT
GUITAR IN
1–4
Mic
OUTPUT
1 Connect the included AC/AC power supply.
Connect the AC/AC power supply to the AC/AC
power supply connector of the D16. Then plug the
other end into an AC outlet.
2 Connect your audio monitoring system.
Use RCA phono cables to connect a powered mon-
itor system (separately sold option: PM-15B ampli-
fied speakers) etc. to the [MONITOR OUT L/R]
jacks.
If you will be monitoring through headphones,
connect the 1/4" phone plug of your headphones
to the [PHONES] jack.
The audio signal that is output from the [MONI-
TOR OUT L/R] jacks and the [PHONE] jack is set
in the [SOLO/MONITOR] "Monitor" tab page.
( p.84)
3 Connect your input devices.
Hard disk drive, CD-R/RW drive
removable disk drive (MO, zip, jaz etc.)
SCSI
Powered monitors etc.
sequencer
MIDI
IN/OUT
SCSI
MONITOR
AC/AC power
OUT L/R
supply connector
Power supply connection
EXPRESSION
PEDAL
FOOT SWITCH
PHONES
Keyboard
MIDI
MIDI
OUT/IN
to the AC outlet
You must use the
included AC/AC power
supply
EXP-2
expression pedal
PS-1
pedal switch
Headphones
11
- Quick Links:
- Features
Hide quick links:
Advertisement
Table of Contents
