Hisense I6433C7 Instructions Manual page 29

First, feed the power cord through the cutout. Place the appliance over the centre of the cutout.
Connect the appliance to the power mains (see instructions for connecting the appliance). Before
sealing the appliance, test its operation. Seal the slot between the appliance and the countertop using
a silicone sealant. The silicone sealant used to seal the appliance has to be temperature-resistant (to
at least 160 °C). Smooth out the silicone sealant using a suitable tool. Observe the instructions for
use of the selected silicone sealant. Do not switch on the appliance until the silicone sealant has dried
completely.
WARNING!
Pay particular attention to built-in dimensions with (natural) stone countertops. When choosing
the silicone sealant, observe the countertop material and consult the countertop manufacturer.
Use of inappropriate silicone sealants can result in permanent discolouration of some parts.
Removing the built-in appliance
Disconnect the appliance from the powermains. Use a suitable tool to remove the silicone gasket from
the perimeter. Remove the appliance by pushing it upwards from the bottom side.
WARNING!
Do not attempt to remove the appliance from the upper side of countertop.
WARNING!
The service department shall only be responsible for repair and servicing of the cooking hob.
Consult your specialized kitchen equipment dealer regarding the re-installation (of the flush-mount)
cooking hob.
Stone countertop
1. Silicone sealant
2. Sealing tape
1. Countertop
2. Appliance
3. Slot
29