Advertisement
Plugging in the sprayer
1. Check that the ON/OFF switch is in the
OFF (O) position.
Pressure relief procedure
Be sure to follow the "Pressure relief" procedure when shutting the unit off FOR ANY
PURPOSE. This procedure is used to relieve pressure from the spray hose.
1. Lock the spray gun off (see di-
rections above). Flip the ON/OFF
switch to the OFF position.
Purging and priming the sprayer
All new units are performance-tested at the factory and are shipped with test fluid in the fluid section to
prevent corrosion during shipment and storage. If you have already used your pump, some water or
solvent used in cleaning may remain in the fluid section. Whether your sprayer is new or you have
already used it, this fluid must be purged and thoroughly cleaned out of the system prior to use. Follow
the steps below:
https://www.XPOtool.com
The Tool Experts
2. Plug the power cord into an earthed outlet or
heavy-duty earthed extension cord. Plug in the ex-
tension cord. Refer to "Important electrical infor-
mation."
2. Turn the PRIME/SPRAY knob
to PRIME.
Item 63003
3. Unlock the spray gun and trig-
ger spray gun into the side of the
material bucket. Re-lock the
spray gun.
Page 9
01
2022-1
Advertisement
