Advertisement
Tip! Trigger gun after starting the stroke. Re-
lease the trigger before ending the stroke. The
spray gun should be moving when the trigger
is pulled and released.
Overlap each stroke by about 30 %. This
will ensure an even coating.
If you expect to be away from your sprayer
for more than one hour, follow the Short-
term storage instructions.
Spraying troubleshooting – unclogging the spray tip
If the spray pattern becomes distorted or stops completely while the gun is triggered, follow
these steps.
Do not attempt to unclog or clean the tip with your finger.
Note!
Do not use a needle or other sharp pointed instrument to clean the tip. The hard tungsten
carbide can chip.
1. Release the trigger and lock the gun off. Rotate the reversible
tip arrow 180° so that the point of the arrow is toward the rear of
the gun (CLEAN position).
Under pressure, the spray tip may be very difficult to turn.
Turn the PRIME/SPRAY knob to PRIME and trigger the gun.
This will relieve pressure and the tip will turn more easily.
2. Turn the PRIME/SPRAY knob to SPRAY.
3. Unlock the gun and squeeze the trigger, pointing the gun at a
scrap piece of wood or cardboard. This allows pressure in the
spray hose to blow out the obstruction. When the nozzle is clean,
material will come out in a straight, high-pressure stream.
If material still will not spray from the spray tip, follow the
"Cleaning the spray gun filter instructions."
4. Release the trigger and lock the gun off. Reverse the tip so
that the arrow points forward again (SPRAY position). Unlock the
gun and resume spraying.
https://www.XPOtool.com
The Tool Experts
Item 63003
Gun locked
Gun unlocked
Page 12
01
2022-1
Advertisement
