Advertisement
4
Return pipe
5
Return valve assembly
Assembly
Do not plug in the sprayer until the setup is complete!
Tools needed for assembly
•
Two adjustable wrenches
•
3
⁄
" Allen wrench
16
•
Extension cord (refer to "Important electrical information")
1. Thread the high-pressure hose to the spray
hose port. Tighten with an adjustable wrench.
3. Thread the suction tube onto the inlet valve
and tighten firmly by hand. Be sure that the
threads are straight so that the fitting turns freely.
5. Verify that the seal is present inside the suction tube. Thread the inlet filter into the end
of the suction tube.
Before commissioning
This section contains instructions that will be repeated throughout this manual.
Locking the spray gun
Note!
Always lock the trigger off when attaching the spray tip or when the spray gun is not in
use.
The gun is locked when the trigger lock is at a 90° angle (perpendicular to the trigger in either direction).
https://www.XPOtool.com
The Tool Experts
9
Spray hose
2. Thread the other end of the hose to the spray gun.
Hold the gun with one adjustable wrench, and tighten
the hose nut with the other.
The spray tip SHOULD
NOT be attached until
after the sprayer and
the spray hose have
been purged and
primed.
4. Press the return tube onto the return tube fitting.
Squeeze clip over the return tube fitting to secure the
return tube.
Item 63003
Page 8
01
2022-1
Advertisement
