Advertisement
4. Release trigger. Turn the PRIME/SPRAY
knob to PRIME. Turn the pump OFF (O). Trigger
the gun into the waste container to be sure that
no pressure is left in the hose.
Note!
Be sure that the paint hose is free of kinks and clear of objects with sharp cutting edges.
Practice spraying technique
1. Switch the pump ON (l). Turn the
PRIME/SPRAY knob to SPRAY. Turn the
pressure control dial to maximum pressure
(+). The spray hose should stiffen as paint be-
gins to flow through it.
The key to a good result is an even coating over the entire surface. This is done by using even
strokes. The tips below will help you to achieve a good result.
Tip! Keep the spray gun at right angles to
the surface. This means moving your entire
arm back and forth rather than just flexing
your wrist.
Tip! Keep the spray gun perpendicular to
the surface. Otherwise, one end of the pat-
tern will be thicker than the other.
https://www.XPOtool.com
The Tool Experts
5. Lock the spray gun off. Make sure the saddle and
black seal are in place inside the tip guard nut (refer to
"Components and description"). Thread the spray tip
guard assembly onto the gun. Tighten by hand.
Begin tightening the tip ... to reach the desired spray angled
at this angle
2. When the motor shuts off, unlock the spray gun
and spray a test area to check the spray pattern.
The motor will cycle on and off automatically as
it needs pressure. The pressure control dial can
be adjusted up or down to achieve the desired
spray pattern.
Good spray pattern
Bad spray pattern
(tail forming from too low pressure, clogged tip)
Item 63003
when tight.
Page 11
01
2022-1
Advertisement
