Table of Contents
Advertisement
Firmware rewriting
2.2.2
Action When Data Transfer Fails
• If "NG" appears on the Touch Panel, indicating that rewriting has been unsuccessful (in
which case the Start key lights up red), take the following steps.
1. Perform the data rewriting procedure again.
2. If the procedure is abnormally terminated, change the memory card for a new one and
try another rewriting sequence.
3. If the procedure is still abnormally terminated, change the board that has caused "NG"
and carry out data rewriting procedure.
APP
MFP Control Board (PWB-MFP)
Font
MFP Control Board (PWB-MFP)
2-6
Service Manual
Ver.1.0 Mar. 2004
Y103290-2
Advertisement
Table of Contents
