Parts List PARTS LIST Part No. Description Q’ty Part No. Description Q’ty Main Frame-L End Cap Main Frame-R End Cap Allen Bolt M12x75mm Top Cross Frame (3”) Sliding mechanism assembly – L Sliding mechanism assembly – R Barbell Hex Bolt M10x50mm (2”) Allen Bolt M12x25mm...
Assembly ASSEMBLY STEP Note: Before starting assembly remove all parts and hardware from the carton, ensure you have everything according to the list. Step 1 Please connect the Top Cross Frames (3)and Lower Cross Frame (41)to the Main Frames (1&2), using 4 Allen Bolts (26), 12 Flat Washers (29) and 8 Lock Nuts (32). Note: Please tighten all the nuts and bolts with wrenches.
Page 8
Assembly Step 2 Please loosen the Allen Bolt (35) and pull up the Smith Guide Rod (11). Please connect the Barbell (6) to the Guide Rod (11), then pull down the Guide Rod (11) and tighten the Allen Bolt (35). Connect the Counter Balance Cable (21) to the Sliding Mechanism by remove the Flat Washer at the end of the cable, connect the Cable to the hole in the Sliding Mechanism, tighten it with 2 Bolts.
Page 9
Assembly Step 3 Please install the Weight Plate Storage Bar (10&39) to the Main Frames (1&2), Using 12 Allen Bolts (28) and 12 Flat Washers (29). Please tighten all the Bolts with Allen wrench.
Page 10
Assembly Step 4 Please install the Stretch Cords Holder (40) to the Main Frame (1), Using 8 Flat Washers (30) and 4 Allen Bolts (38). Please tighten all the Bolts with Allen wrench.
Need help?
Do you have a question about the 872SM-B and is the answer not in the manual?
Questions and answers