Recording Audio (Digital Sources) - Kenwood VR-9050 Instruction Manual

Recording

Recording audio (digital sources)

Switch on the REC MODE to record a digital input source.
Usually use the REC MODE AUTO to record audio input sources. When
the digital mode changes during recording in the REC MODE AUTO, the
audio input source may be interrupted momentarily.
Recording music in REC MODE AUTO or MANUAL
DIMMER
Input Selector keys
Input Selector
keys
1 Use the Input Selector keys to select the source (CD/DVD, DVD/
6CH, VIDEO 2, VIDEO 3) you want to record.
2 Set the MD or TAPE recorder to record.
3 Press and hold the DIMMER key for more than 2 seconds to select
the REC MODE AUTO or MANUAL.
1 REC MODE off
: The digital input record mode is switched
2 REC MODE AUTO
: The digital input signals (DTS, Dolby Digi-
3 REC MODE MANUAL : The input signal type at the moment this
• When the REC MODE MANUAL is selected, the digital input signal
is converted to stereo signals (down-mix). But once the digital signal
is changed to other signal, no signal is output.
When the REC MODE AUTO is selected, the digital input signal is
converted to stereo signals even if the digital signal is changed.
off.
tal, or PCM) are identified automatically
and converted into stereo signals that
are ready for recording.
mode is selected is held throughout this
mode.
For REC MODE AUTO :
SP MUTE
AUTO DETECT DIGITAL
A B CLIP
L C R
LFE
SL S SB SR
SP MUTE
AUTO DETECT DIGITAL
A B CLIP
L C R
LFE
SL S SB SR
For REC MODE MANUAL :
SP MUTE DIGITAL
A B CLIP
L C R
LFE
SL S SB SR
SP MUTE
DIGITAL
A B CLIP
L C R
LFE
SL S SB SR
4 Start playback, then start recording.
• If the audio reproduction stops in the middle due to change in the
input signals, etc., press the DIMMER key.
STEREO
STEREO
STEREO
STEREO
23 EN