Step 1 - WCP Omio CNC Router Stand User Manual

Omio CNC Router Stand (Mobile Cart) -
User Guide (Rev 1)

Step 1

2" x 2" Tube Plug
Slide a 2" x 2" tube plug into the tube. Align the tapped holes on the sides of the tube
plug with the clearance holes in the tubing. Install the six #10-32 x 3/8"L BHCS.
Repeat this step on all 2" x 2" tubing that has the same hole pattern on the ends. There
will be 33 plugs in total that need to be installed.
Note: Some plugs may not be a slip fit and may need to be tapped in with a mallet. This
is due to the inconsistency with the tubing.
Table of Contents Page 7
wcproducts.com