Step 8 - WCP Omio CNC Router Stand User Manual

Omio CNC Router Stand (Mobile Cart) -
User Guide (Rev 1)

Step 8

Install all tubes as shown in the locations shown below. Use four #10-32 x 3/8"L bolts to
secure each end of tube in place. Install as many sets of dividers as desired.
Note: Some angle iron may be installed on the wood base directly under each 1" x 1"
piece of tubing to help prevent sheets from sliding around, if the cart will be moved
often� This is an optional addition and parts are not included�
Table of Contents Page 16
wcproducts.com