WCP Omio CNC Router Stand User Manual page 9

Omio CNC Router Stand (Mobile Cart) -
User Guide (Rev 1)
1"x1" Tube Plug (1/8" Wall Tubing)
Slide a 1" x 1" tube plug into the tube. Align the tapped holes on the sides of the tube
plug with the clearance holes in the tubing. Install the two #10-32 x 3/8"L BHCS.
Repeat this step on all 1" x 1" x1/8" tubing that has the same hole pattern on the ends.
There will be ten plugs in total that need to be installed.
Note: Some plugs may not be a slip fit and may need to be tapped in with a mallet. This
is due to the inconsistency with the tubing.
Table of Contents Page 9
wcproducts.com