Connecting To A Tv With Component Input Terminals (For Some Areas); Connecting To An Audio Component - Kenwood DV-705 Instruction Manual

12
Connecting to a TV with Component input terminals
TV
Component cords
Audio cord

Connecting to an Audio component

For playback of DTS audio, please connect an AV receiver or an AV amplifier which can decode DTS by digital con-
nection.
TV
Video cord or S-video cord
TV
Video cord, S-video cord or
Component cords
1. In case an associated system component is connected, also read the instruction manual of the component.
2. Insert the optical-fiber cable straight into the connector until it clicks.
Notes Notes Notes
3. Never bend or bundle the optical-fiber cable.
AV receiver or
AV amplifier
Video cord or S-video cord
Audio cord
Coaxial or Optical cable
AV receiver or
AV amplifier
Video cord, S-video cord or
Component cords
Audio cord
Coaxial or Optical cable
(For some countries)
[ For U.S.A., Canada and U.S. Military]
Select the scanning method of the Component
Video output using the COMPONENT VIDEO OUT-
PUT switch on the rear panel.
INTERLACE: Scanning method is fixed at interlaced
scanning.
PROGRESSIVE: When progressive scanning is un-
available with certain discs, the scanning method is
switched automatically to interlaced scanning.
When the scanning method is changed, the scan-
ning status will be displayed for a few seconds.
Please note that when PROGRESSIVE is
Note Note Note
selected, only COMPONENT VIDEO
OUTPUT is available, while other video
output is not present.
(For Europe)
AV
(For other countries)
System Connections
DV-705/DVF-R5070 (EN/K,P,E,Y)