Set Up Functions - Kenwood DV-705 Instruction Manual

Set Up functions

16
Preparation for Set Up
1 Set the POWER ON/OFF switch
to the ON ( ) position.
POWER
-ON –OFF
÷ After the power is switched ON, there is a
delay of about 3 seconds before the dis-
play is lit.
Set up menu
The SETUP functions are the following diverse functions. Please change them according to your use environment.
Language Set up
OSD Language
This switches the language for the on-screen display.
Audio Language*
Choose the language for the AUDIO output. ( ENGLISH )
Subtitle Language*
Choose the language for SUB TITLE. ( ENGLISH )
Menu Language*
Choose the language for the menu recorded on the DISC. ( ENGLISH )
* When "Original" is selected for items marked with an asterisk (*), automatic switching to the language initially
set for the disc will be done.
Please refer to Page 26 for the languages compatible with this model.
Audio Set up
Digital Output
This selects the format of the audio output from the DIGITAL OUT terminal.
BitStream
Choose this when connecting to an amplifier with built-in Dolby digital or DTS decoder.
When a DVD recorded with Dolby digital or DTS is played back, a bitstream signal will be put out.
When a disc recorded with linear PCM is played back, a linear PCM signal will be put out.
LPCM
Choose this for PCM output.
When a DVD recorded with Dolby digital is played back, output will be made converted to 2-channel
PCM.
And when a DVD recorded with DTS is played back, a bitstream signal will be put out.
LPCM Output
This selects the clock frequency for linear PCM output.
96kHz
In case of 96 kHz digital signal, DVD will deliver 96 kHz signal out. In this case your receiver should
control 96 kHz signal.
48kHz
Sets the linear PCM output to 48 kHz.
Even in case of 96 kHz digital signal, DVD will
deliver 48 kHz signal out.
The items in are the initial set values.
2 Set TV Format according to the connected TV type.
(Initial Settings 9)
MAIN UNIT
ANGLE
+
( ENGLISH )
With no disc inserted, keep the ANGLE
key on the remote control pressed and
REMOTE
press the STOP key on the main unit. Each
time the STOP key is pressed, the setting
will be switched as follows.
1 NTSC
2 MULTI (NTSC/PAL switchable)
3 PAL
How to use the RETURN key
When the RETURN key is
pressed, the display returns to
the previous screen (STOP
mode).
Set Up functions
DV-705/DVF-R5070 (EN/K,P,E,Y)
RETURN