(For Europe); Connecting To A Tv With Component Input Terminals; (For Some Areas); Connecting To An Audio Component - Kenwood DVF-3070 Instruction Manual

Connecting to a TV with Component input terminals

TV
Audio cord
Component cords

Connecting to an Audio component

For playback of DTS audio, please connect an AV receiver or an AV amplifier which can decode DTS by digital con-
nection.
TV
Video cord or S-video cord
TV
Video cord, S-video cord or Component cords
When connecting to the S-VIDEO terminal, the SCART terminal, or the COMPONENT VIDEO OUTPUT terminal of this
unit, also connect the composite video cord. In addition, perform the VIDEO OUTPUT setting at the SETUP MENU
Note Note Note
screen. ("Select VIDEO OUTPUT"))
When SCART (or COMPONENT) terminal connection is made without connecting the composite video cord and this
unit is set to S-VIDEO, the monitor will not display correctly. (The setting cannot be changed to RGB or COMPONENT)
1. In case an associated system component is connected, also read the instruction manual of the component.
2. Insert the optical-fiber cable straight into the connector until it clicks.
Notes Notes
Notes
3. Never bend or bundle the optical-fiber cable.
AV receiver or
AV Amplifier
Coaxial or Optical cable
Audio cord
AV receiver or
AV Amplifier
Coaxial or Optical cable
Audio cord

(For some areas)

[ For some areas ]
Select the scanning method of the Component
Video output using the COMPONENT VIDEO
OUTPUT switch on the rear panel.
INTERLACE: Scanning method is fixed at inter-
laced scanning.
PROGRESSIVE: When progressive scanning is
unavailable with certain discs, the scanning
method is switched automatically to interlaced
scanning. When the scanning method is
changed, the scanning status will be displayed
for a few seconds.

(For Europe)

(For other countries)
11
System Connections
DVF-3070 (EN/E,X,Y)