IKEA CIRKULERA Manual page 30

BEFORE YOU CALL
Cooktop Problems
Problem
Cannot move appliance
easily. Appliance must be
accessible for service.
Entire appliance does not
operate.
Surface burners do not
ignite.
Surface burner fl ame
uneven or only part way
around burner cap.
Surface burner fl ame is
too high.
Surface burner fl ame is
orange.
30
Cause / Solution
Cabinets not square or are built in too tightly. Contact builder or installer to
make appliance accessible.
Carpet interferes with appliance. Provide suffi cient space so appliance can be
lifted over carpet.
Make sure power cord is plugged properly into outlet.
Electrical power outage. Check house lights to be sure. Call your local electric
company for service outage information.
Surface control knob was not completely turned to LITE ( ). Push in and turn
the surface control knob to LITE until the burner ignites and then turn the
control knob to the desired fl ame size.
Burner ports are clogged. With the burner OFF and cool, use a small-
gauge wire or needle to clean the burner head slots and ignition ports. See
"Cleaning the Sealed Burners" in the Care & Cleaning section on page 24 for
additional cleaning instructions.
Range power cord is disconnected from outlet (electric ignition models only).
Be sure the power cord is securely plugged into the power outlet.
Circuit is broken. Check breaker box or fuse box.
Electrical power outage. Burners may be lit manually. See "Setting Surface
Controls" on page 15.
Burner slots or ports are clogged. With the surface burner OFF and cool, clean
ports with a small-gauge wire or needle. If moisture is present after cleaning,
lightly fan the fl ame and allow the burner to operate until fl ame is full.
Burner caps are not seated properly. Check that all burner caps are level and
seated correctly on the burner heads. See "Cleaning the Sealed Burners" in
the Care & Cleaning section on page 24 for additional cleaning instructions.
Surface control knob is set too high. Adjust to a lower fl ame setting.
Burner caps are not seated properly. Check that all surface burner caps are
level and seated correctly on the surface burner heads. See "Cleaning the
Sealed Burners" in the Care & Cleaning section on page 24 for additional
cleaning instructions.
Incorrect L.P. conversion. Refer to L.P. conversion kit instructions to correct.
Dust particles in main gas line. Allow the burner to operate a few minutes
until fl ame turns blue. In coastal areas, a slightly orange fl ame is unavoidable
due to salt content in the air.
Incorrect L.P. conversion. Refer to L.P. conversion kit instructions to correct.
EN