Stihl TS 400 Manual page 29

STIHL TS 400
• Press hook of torsion spring into
middle of wire cross-section
approx. 15 mm from the end of
the ignition lead.
• Pull back ignition lead until torsion
spring rests in the slot in the spark
plug terminal.
- Slide cover over spark plug
terminal.
- Press ignition lead into holder.
- Plug spark plug terminal onto
spark plug.
- Install shroud, see 5.5.
6.2 Ignition lead
- Draw spark plug terminal off
spark plug, see 6.1.
- Dismantle ignition module,
see 6.3.2.
• Draw ignition lead out of
retainers.
• Draw protective sleeve off
ignition lead.
• Dismantle spark plug terminal,
see 6.1.
- Cut new ignition lead to correct
length (as specified in spare parts
list or same length as former lead).
• Use a sharp implement to pierce the
centre at the end of the ignition lead
which is to be turned into the ignition
module.
Note: Before turning in the ignition
lead, the high-voltage output must be
filled with STIHL multi-purpose grease,
see 11.2.
Caution! Graphite (Molykote) grease
and silicone insulating paste must not
be used.
- Install ignition module, see 6.3.2.
- Insert ignition lead in retainers.
- Plug spark plug terminal onto spark
plug.
- Install shroud, see 5.5.
29