Changing The Room Temperature - Bosch HPC 400 Operating Instructions Manual

Operating the appliance
To activate optimised operation (without time program, default setting)
▶ Press the menu key to open the main menu.
▶ Press the selector to open the Heating/Cooling menu.
▶ Press the selector to open the Operating mode menu.
▶ If two or more heating circuits are installed, turn the selector to highlight Heating
circuit 1, 2, 3 or 4 and press the selector.
▶ Turn the selector to highlight Optimise and press the selector.
▶ Press and hold the Back key to return to the standard display.
The required room temperature is shown in a pop-up window in the lower part of the
display. The user interface will now constantly maintain the required room
temperature.
Table 5 Getting started – Activating operating modes
4.3

Changing the room temperature

Operating the appliance
If it is too cold or too warm for you today: Change the room temperature temporarily
Changing the room temperature until the next switching time
▶ Turn the selector to set the required room temperature.
The corresponding time slot is displayed in grey in the time program bar chart.
▶ Wait a few seconds or press the selector.
The user interface operates with the modified setting. The change applies until
the next switching time in your heating system time program is reached. After
this, the time program settings are restored.
Undoing a temperature change
▶ Turn the selector until the corresponding time slot turns back to black in the time
program bar chart and press the selector.
The change is undone.
Should it be permanently too cold or too hot for you: Set the required room temperature
▶ Activate optimised operation ( Chapter 4.2).
▶ Wait a few seconds or press the selector to close the pop-up window.
▶ Turn the selector to set the required room temperature.
▶ Wait a few seconds or press the selector. Press the selector to confirm the
change in the pop-up window (or press the back key to discard the change).
The room temperature that is currently valid is shown in a pop-up window in the
lower part of the display.
The user interface operates with the modified settings.
Table 6 Getting started – Room temperature
HPC 400
CLIMATE CONTROL SYSTEMS
VOGEL NOOT
&
Getting started | 9
Result
6 720 812 775-04.1O
Result
6 720 812 775-05.1O
6 720 812 775-06.1O
6 720 817 986 (2015/07)