Bosch HPC 400 Operating Instructions Manual page 34

34 | Calling up information about the system
Operating the appliance
Call up information about the solar system
▶ If the standard display is active, press the info key to open the info menu.
▶ Turn the selector to highlight Solar.
▶ Press the selector to open the Solar menu.
▶ Turn the selector to mark the Solar sensors menu item and press the selector.
The current temperature at the temperature sensor with the lowest number is
displayed. The number in the graphic indicates the position of the temperature
sensor in the system, e.g. temperature cylinder 2 bottom [5].
▶ Turn the selector to call up more temperatures.
The graphics in the info menu in the solar system show the installed pumps, mixers
and valves. When a pump is running the symbol for the pump
triangles in the symbols for mixers or valves indicate the direction in which the heat
transfer medium is flowing.
Information about solar yield
▶ If the standard display is active, press the info key to open the info menu.
▶ Turn the selector to highlight Solar.
▶ Press the selector to open the Solar menu.
▶ Turn the selector to highlight Solar yield and press the selector.
The solar yields for the current week are displayed.
▶ Turn the selector to switch the display between solar yield for the current week, solar
yield for last week and total yield of solar system since commissioning.
Table 44 Call up information about the solar system
Menu item: Outside temperature
The currently measured outside temperature is displayed in
this menu. In addition, a diagram of the outside temperature
profile for today and yesterday (from 00:00 to 24:00 in each
case) is displayed here.
6 720 817 986 (2015/07)
CLIMATE CONTROL SYSTEMS
is rotating. Solid
VOGEL NOOT
&
Result
6 720 811 136-38.1O
6 720 811 136-40.1O
6 720 811 136-39.1O
6 720 811 136-41.2O
HPC 400