More Settings - Bosch HPC 400 Operating Instructions Manual

10 | Getting started
Operating the appliance
▶ Press the menu key to open the main menu.
▶ Press the selector to open the Heating/Cooling menu.
▶ Turn the selector to highlight the Temperature settings menu.
▶ Press the selector to open the menu.
▶ If two or more heating circuits are installed, turn the selector to highlight
Heating circuit 1, 2, 3 or 4 and press the selector.
▶ Turn the selector to highlight Heating, Setback or Cooling.
▶ Press the selector.
▶ Turn the selector and press it to activate the required setting, e.g. for setback
mode.
▶ Turn and press the selector to set the temperature. The limits of the setting
values for the temperatures are determined by the settings for the other
operating mode in each case.
The user interface operates with the modified settings. The settings are applied
to all time programs for the heating system (if two or more heating circuits are
installed, it is only applied in the selected heating circuit).
Table 6 Getting started – Room temperature
4.4

More settings

Operating the appliance
If you need hot water outside of the times set in the time program: Activate extra DHW (= immediate DHW function).
▶ Press the extra DHW key.
DHW heating is active immediately with the set temperature and for the set duration.
After a few seconds, the symbol for extra DHW will be displayed in the information
graphic (Extra hot water settings  Chapter 5.3.3, page 21).
To deactivate the extra DHW function before the end of the set duration:
▶ Press the extra DHW key again.
If the DHW is too cold or too hot for you: Change the DHW heating operating mode
▶ Press the DHW key.
The user interface will display a list of the DHW heating operating modes (for more
information  Chapter 5.3.1, page 20).
▶ Turn the selector to highlight the required operating mode.
▶ Press the selector.
The user interface operates with the modified settings. Your contractor can set the
temperatures for the DHW and DHW reduced operating modes.
If optimised mode is active, the temperature will not be changed.
Table 7 Getting started – More settings
6 720 817 986 (2015/07)
CLIMATE CONTROL SYSTEMS
VOGEL NOOT
&
Result
6 720 811 136-07.1O
6 720 811 136-08.1O
Result
6 720 812 775-09.1O
6 720 811 136-10.1O
HPC 400