Led Status Display - VOLTCRAFT DL-210TH SE Operating Instructions Manual

8. LED status display

LED indicator
Green LED control
light (3) is flashing.
Red LED control
light (2) is flashing.
Red LED control
light (2) is continu-
ously on.
Green LED control
light is flashing
twice.
Description
Measured value(s) are within the con-
figured limits of low and high alarm.
Memory is full.
Measured value(s) are exceeding
configured limits of low and high
alarm.
In mode "START UPON KEYPRESS"
or "STOP TIME" recording has been
terminated. (In order to start recording
again, re-configure data logger.)
In mode "START UPON KEYPRESS",
data logger is ready to start recording.
(In order to start recording hold button
ENTER (8) pressed for few seconds.)
Data logger is generating PDF report.
Configuration was successful.
Firmware has been updated success-
fully.
79