C) Create Pdf Report; D) Delete Data - VOLTCRAFT DL-210TH SE Operating Instructions Manual

c) Create PDF Report

• Connect the data logger to your computer.
• A PDF report is produced automatically. Red LED control light
(2) is on and "USB PDF" is shown in the LC display (5). Do not
disconnect the data logger from your computer during this period.
• Open the data logger drive on your computer.
• Once the PDF file has been generated successfully, "PDF" dis-
appears from the LC display. "USB" remains on the LC-display.
• Select and open the PDF file.
• The PDF report contains general device information, data log-
ger settings, alarm statuses and a graph showing the meas-
ured values during the recorded time.
• Save the PDF file on your computer and close the file.
• Disconnect the data logger from your computer.
Depending on the number of stored measurements,
generating the PDF file may take up to approximately
30 seconds.
Only the maximum and minimum measurements dur-
ing recording will be shown in the PDF report but not
during the pause function.

d) Delete data

Generate and save the PDF report before deleting
measured data, if needed.
Deleting data does not affect the configuration settings.
107