Led Status Display - VOLTCRAFT DL-200T Operating Instructions Manual

8. LED STATUS DISPLAY

LED indicator
Green LED
control light (3)
is flashing.
Red LED
control light (2)
is flashing.
Red LED
control light (2)
is continuously
on.
Green LED
control light is
flashing twice.
No LED light
is on.
66
Description
Measured value(s) are within the configured limits of
low and high alarm.
Memory is full.
Measured value(s) are exceeding configured limits of
low and high alarm.
In mode "START UPON KEYPRESS" or "STOP
TIME" recording has been terminated. (In order to
start recording again, re-configure data logger.)
In mode "START UPON KEYPRESS", data logger is
ready to start recording. (In order to start recording
hold button ENTER (8) pressed for few seconds.)
Data logger is generating PDF report.
Configuration was successful.
Firmware has been updated successfully.
LED-alarm was disabled during configuration.