Presetting Stations - JVC CA-EX90 Instructions Manual

Presetting Stations

Once stations are preset, they can be called up quickly with preset tuning. You can preset a total of
40 stations, either FM or AM.
1
4
7
10
26
CA-EX90
2 3
6
5
9
8
+ 10
1 Tune in the station you want to preset.
Use the buttons on the remote control to tune in the
station; otherwise, following operation will not be
possible.
2 Press SET.
The unit switches to preset memory mode ("— —" and
PRESET blink in the display).
Proceed to step 3 during the 4 seconds that "— —"
and PRESET are blinking. After 4 seconds, preset
memory mode is released. If this happens, press SET
again to reactivate it.
3 Use the number buttons on the remote
control to specify the preset number you
desire.
The preset number and PRESET blink in the display.
Proceed to step 4 during the 4 seconds that the preset
number and PRESET are blinking. After 4 seconds,
preset memory mode is released. If this happens, start
again from step 2.
4 Press SET again.
"MEMORY" is displayed and the station is stored at the
selected preset number.
If another station was previously stored at that preset
number, that station is erased and the new station is
memorized in its place.