Listeningto Fm And Am Broadcasts; Tuningin A Station; Presetting Stations; Tuningin A Presetstation - JVC MX-GT90 Instructions Manual

Listeningto FM and AM Broadcasts
Tuningin a Station
1
Press FM/AM.
The unit automatically turns on and
tunes in the previously tuned station
(either FM or AM).
• Each time you press the button, the
band alternates between FM and AM,
2 Start searching tbr stations.
On the unit:
Press and hold TUNING +
or TUNING - tbr more than
1 second.
On the remote control:
Press and hold I_1_1 or I_1_1 _" '_
tbr more than 1 second. 0 %
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in,
• ifa program is broadcast in stereo, the ST (stereo)
indicator lights up,
'lb stop searching, press TUNING + or TUNING (or _ /
I,,II41on the remote control),
f_When you press I UNING or 1UNING - (or I_1 / • , •q_ ,, •
1_14 on the remote control) briefly and repeatedly
The frequency changes step by step
Tochangethe FM receptionmode
When an FM stereo broadcast is hard to receive _'_
or noisy, press FM MODE on the remote
control so that the MONO indicator lights up
on the display, Reception improves,
'lb restore the stereo effect, press FM MODE again so that
the MONO indicator goes off, In this stereo mode, you can
hear stereo sounds when a program is broadcasted•
Presetting Stations
You can preset 30 FM and 15 AM stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment, This is not a malfunction• You can
preset the stations you want into memory by following the
presetting method•
• There is a time limit in doing the following steps, if the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1 Tune in the station you want to preset.
• See "Tuning in a Station,"
The tuned station in step 1 is stored in the
preset number selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuningin a PresetStation
1
2
Press FM/AM.
The unit automatically turns on and
tunes in the previously tuned station
(either FM or AM).
• Each time you press the button, the
band alternates between FM and AM.
Select a preset number.
On the unit:
Turn PRESET + / -.
On the remote control:
Press the number buttons.
Ex,: For preset number 5, press 5.
For preset number 15, press
+10 then 5,
For preset number 20, press
+10, then 10,
For preset number 25, press
+10, +10, then 5.
For preset number 30, press
+10, +10, then 10,
CD CD CD
4 6 8
CD CD CD
7 8 8
CD CD CD
CD
-12-