Connections - JVC CA-EX90 Instructions Manual

Place the EX series as shown below.

Connections

Before Making Any Connections
• Be sure to confirm the locations of the left and right, + and –, and IN and OUT terminals on each
component and make connections correctly and firmly. Incorrect or incomplete connections may
result in degradation of the stereo effect, or no sound at all. As a general rule, use the red plugs
on the connecting cords to connect the right channels and the white plugs to connect the left
channels.
• Do not connect the AC power cord until all other connections are complete.
Connecting the supplied antennas
Connect the supplied FM (wire) antenna and AM loop antenna as shown below.
FM antenna
Affix the antenna to a wall (etc.) in a position which provides the best reception.
AM loop antenna
Fold the loop over the base and push in the direction of the arrow.
Place in a position which provides the best reception.
CAUTION
To avoid noise, keep antennas away from this unit's metallic parts, the audio pin cords, and the AC
power cord.
Connecting external antennas
• Connect external antennas if reception is not satisfactory with the supplied antennas.
AM loop antenna
Outdoor single
vinyl-covered wire
Twist one end AM
loop antenna's wire
together with the vinyl
wire and insert.
• To improve reception of FM stations, disconnect the supplied FM wire antenna and connect an
75-Ohm FM antenna wire (not supplied).
• To improve reception of AM stations, connect an vinyl-covered wire (not supplied) to the AM EXT
terminal in addition to the supplied AM loop antenna.
14
CA-EX90
FM
AM AM
FM
GNDGND
(75 )
EXT LOOP
ANTENNA
AM AM
GNDGND
EXT LOOP
ANTENNA
AM loop antenna
1
FM
FM
(75 )
Outdoor single vinyl-covered wire
FM wire antenna
2
3 Outdoor FM
antenna
AM loop antenna