Common Malfunction And Solution - HOMCOM A90-201V70 Assembly Instruction Manual

Malfunctions
Treadmill does
not work
Running belt dose
not move
smoothly
E01
E02
E05
E07
Other malfunctions and solutions
1. Control panel does not work
a.Check whether the power cord is connected correctly, whether the switch is on, or whether the fuse
on the control panel is blew.
b.Check whether the control panel is well connected to the display.
c.Check whether the control panel is well connected to the transformer.
2.The HR function does not display well
a.Check whether the connecting line of HR is firmed.
b.Check whether your hands touch the inducting point
c.Please wash your hands and keep your hands wet.
3.Motor does not work
a.Please check whether all wires are well connected.
b.Please check the error code on display.
4.Touching screen does not work well
a.Please check whether the screen is wet
b.If there is too much sweat in your hands.
Common malfunctions and solutions
Cause
Unplug
Emergency Stop device
is not in the right place
Single wire or
supply broken
Switch off
Not enough lubricating
Running belt is too tight
Control panel does not
work
Motor line disconnected
Over voltage protection
Emergency stop device
falls off
Solution
Connect the power cord
Put the emergency stop device on the right
place in control panel
power Check signal wire
Switch on
Lubricate with silicone oil
Adjust the intensity of the running belt
Check whether the communicating wire is
broken or unplug
Check whether the motor line is disconnected
or not connect well.
Turn off the product and turn on again the
product will be ok.
Put the emergency stop device on the yellow
place of control panel.