Using The Push Button Door Control 883Lmw; Remote Control - Chamberlain LM-W8ME Manual

Operation and Maintenance
Wi-Fi Status
LED Defi nition
Blue Off - Wi-Fi is not turned on.
Blinking - Garage door opener is in Wi-Fi learn mode.
Solid - Mobile device connected to the garage door opener.
Blue and Green Blinking - Attempting to connect to router.
Green Blinking - Attempting to connect to the Internet server.
Solid - Wi-Fi has been set up and garage door opener is connected to
the Internet.

Using the Push Button Door Control 883LMW

SYNCHRONIZE THE DOOR CONTROL
Learn
To synchronize the door control to the garage door opener, press the push button until the garage door
Button
opener activates (it may take up to 3 presses). Test the door control by pressing the push button, each
press of the push button will activate the garage door opener.
LED
PUSH BUTTON
Press the push button to open or close the door.
LIGHT/LEARN BUTTON
An LED on the garage door
Press the LIGHT button to turn the garage door opener lights on or off . When the lights are turned on
opener will indicate Wi-Fi
they will stay on until the LIGHT button is pressed again, or until the garage door opener is activated.
status. See table below.
Once the garage door opener is activated the lights will turn off after the specifi ed period of time
(the factory setting is 4-1/2 minutes). The LIGHT button will not control the lights when the door is in
motion.

Remote Control

Your remote control has been programmed at the factory to operate with your garage door opener.
Older LiftMaster remote controls are NOT compatible for compatible accessories. Programming can
be done through the door control or the learn button the garage door opener. To program additional
accessories refer to the instructions provided with the accessory or visit LiftMaster-me.com.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING THE MULTI
FUNCTION DOOR CONTROL - MODEL 883LMW
1. Press and hold the LIGHT button and the push button until the push button LED begins to blink.
2. Remote Control:
Press the button on the remote control that you wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identifi cation number (PIN) of your choice on the keyless entry keypad.
Then press the ENTER button.
The garage door opener lights will fl ash (or two clicks will be heard) when the code has been
programmed. Repeat the steps above for programming additional remote controls or keyless entry
devices. If programming is unsuccessful, program the remote using the learn button.
18
Push Button LIGHT/LEARN
Button