Factory Settings; Preparing Machine For The First Time; Adding Coffee Beans - Jura Capresso 64701R1 Operating Instructions And Warranty

All Display Messages Are Shown in

5. FACTORY SETTINGS

Each machine leaves the factory with the following settings:
Filter ..................... NO
Hardness Level .... 2
Aroma ................... ROBUST
Auto Off ................ 2 hours after last use
Language ............. English
Cup Size .............. OZ.
Rinse .................. 
The Dial is set to 4 OZ. for coffee and for hot water and
for 60 SEC for steam.
6. PREPARING THE MACHINE FOR THE FIRST TIME
• Make sure all accessories, literature and any other items are
removed from the machine and the water tank.
• Make sure the machine sits on an even, flat surface and the
drawer, tray and used coffee container are inserted (Fig 2).
• Plug-in machine.
• Do NOT fill water tank now.
Important: Do not install the Clearyl Water Filter cartridge
now. It can block the machine.
• Turn the machine on by pressing the ON/OFF button (Fig. 3a).
The display shows FILL WATER.
• Remove water tank, fill with fresh, cold water and replace.
The display shows OPEN TAP
The following procedure is only necessary when setting up the
machine for the first time and after the procedure "Emptying
System Before Transport" (chapter 19f).
RED • Place a cup underneath the frother (Fig. 13) and turn the
Steam/Water Selector to the Steam / Water symbol Fig 4b).
SYSTEM
through the frother and stop automatically.
the Steam/Water Selector back to the cup symbol. HEATING.
PRESS
(Fig. 1,1) and press the Rinse Button (Fig. 3f). The machine will
pump a bit of hot water through the coffee spouts and will
stop automatically. READY. You can only brew coffee when
the display shows READY.
• Open the bean container lid (Fig. 1, 9) and fill with beans
(Fig. 5) for details see chapter 7.
• Place an empty cup (at least 8 oz.) under the coffee spouts.
• Push the Dial (Fig. 3e). The Dial illuminates and the display
shows the cup size
• Push and hold the 1-Cup button until the display reads STRONG.
The Impressa E starts grinding and will start brewing.
Initially, the grinding chamber may not fill properly with ground
coffee. The machine will start brewing, then interrupt and the
display will show
Discard this first cup of coffee. Your next cup will be perfect.
Please note: If coffee only comes out of one spout, move the
spout up and down a few times to clear the internal flow.
You are now ready to make coffee.

7. ADDING COFFEE BEANS

• Open the bean container lid (Fig. 1, 9), fill with beans (Fig. 5).
The container holds approx. 220 grams (8 oz.). Close the lid.
Frozen Beans: Thaw for 3 to 4 hours before adding to bean
container. This prevents moisture from seeping into the grinder.
11.
FILLING. The machine will pump some water
RINSE. Place a cup underneath the Coffee Spout
4 OZ.
FILL BEANS. Push the 1-Cup button again.
SHUT TAP. Turn