Table of Contents
Advertisement
3. Open interface properties and change in the folder IO cycle the value of the number of cycles without
updating data. If this value won't be not changed, the cpu will continue to generate communication
errors and the module won't recognized on the network, or will continues to give communication
errors.
4. Through assigns name to the device, select the module to be parameterized, define in the confi-
guration of DAT 200 the IP address, see PARAMETERS SERIAL OUTPUT. Assign to the module the
IP configuration and device name; The device name must be the same as defined in the hardware
configuration DEVICE NAME. If the IP address and the NAME UNIT are not defined and equal,
the module is not recognized in the profinet network.
Page 33
Advertisement
Table of Contents
